Tech Tips — May 2014
technical tips are intended for professional reference only. Please refer to
manufacturer’s recommendations as Encompass does not guarantee the accuracy,
reliability or safety of this information.
or replaced the connector between flex and drive PCB.
in picture or screen
50 pin connector, #EK01182, polarity or improper connections.
W624 jumper and replaced the following:
C973, 10uF/50V, D432, and Q431.
just clicks
C916, 10uF/100V, C956, 2.2uF/200V, then discovered the Q532, HOT was
shorted. Replaced it and a 3.15micro fuse
and the set was fixed.
R517 and C524.
after set is on for a while. Audio, OK.
and reseat the LVDS cable between the main and control/logic boards.
LI008 bad. If drawing number on fly is
107 56 Xxx, use 259296. Otherwise use
265409. Also replace TI-010, 2SC2588 and
DI-012, BYW34V, (244834)
by installing a jumper from the cap at bridge diode output to the cathode of
125V SCR. Bring set up on a variac. If the jagged edges go away, replace IC701. RH-IZ0073CEZZ
screen but sound OK
Solution: Bringing
up screen you could see vertical collapsed. Found and repaired bad connections
on IC501 and the yoke plug.
Leave a Reply